Configuring a Web Application Firewall (WAF) for Unified Access Gateway (UAG) traffic with NSX ALB (Advanced Load Balancer) involves several steps. NSX ALB provides application delivery services, including load balancing and WAF capabilities. Here’s a general guide on how you can configure WAF for UAG traffic with NSX ALB:
Prerequisites:
- Ensure that NSX ALB is installed and configured in your environment.
- Have the Unified Access Gateway (UAG) deployed and operational.
Steps to Configure WAF for UAG Traffic:
- Access NSX ALB Console:
- Open a web browser and log in to the NSX ALB administration console.
- Navigate to Services:
- In the NSX ALB console, navigate to the “Services” section.
- Create a New Virtual Server:
- Create a new virtual server for UAG traffic. Configure the necessary settings, such as IP address, port, and protocol.
- Configure Backend Pool:
- Associate the UAG servers with the virtual server by configuring the backend pool. Specify the IP addresses and ports of the UAG servers.
- Enable WAF for the Virtual Server:
- Within the virtual server configuration, find the WAF settings.
- Enable WAF for the virtual server.
- Configure WAF policies and rules based on your security requirements. This may include defining rules to block specific types of attacks or malicious traffic.
- SSL/TLS Offloading (Optional):
- If you are using SSL/TLS, configure SSL/TLS offloading on the NSX ALB to offload the SSL/TLS processing from the UAG servers.
Remember that specific steps and options may vary depending on the version of NSX ALB and UAG that you are using. Always refer to the official documentation for the exact steps and configurations applicable to your environment.
Thinkvirtuals 
Leave a comment